Assembly requires cookies to securely sign you in. On iPhone or iPad, open Settings → Apps → Safari → Advanced and turn off “Block All Cookies.” Then fully close Safari, reopen it, and reload this page.
It was from automatic car so thrust bearing looks good.
I will refresh it with new gaskets arp head studs and new 360 thrust bearing. It should hold 20psi and 300-350ftlb. In a meantime i will check my other m42 block to see of i can build it. I used that block to center the transmission when i was welding the bellhousing. I might have messed up the main bearing caps. I need to get bore dial gauges and verify.
COMMENTS
1
drive_revive_tinker
· Aug 19
I didn't realize you had to rotate and weld the flange on the trans (but makes sense with the vertical orientation). Fingers crossed the new engine lasts a lot longer than the first one.
