Assembly

Assembly requires cookies to securely sign you in. On iPhone or iPad, open Settings → Apps → Safari → Advanced and turn off “Block All Cookies.” Then fully close Safari, reopen it, and reload this page.

Sign in / Sign up
8hp tunnel
Fabrication of a sheet metal trans and driveshaft tunnel

Plan
Decisions & Unknowns
What I need to figure out:
•
driveshaft measurements and plan
•
Rear axle plan?
Tasks
What I need to do:
•
Remove e brake cable and assembly
•
finish cutting trans tunnel to clear 8hp
•
Clean all under coating and paint off welding area
•
Tip body sheet metal into flanges to butt weld tunnel to?
•
Roll and tack 20g sheet to clear trans
•
Check fitment and fully weld
•
Figure out drive shaft size etc.
•
cut out drive shaft tunnel as much as needed
•
Clean DS tunnel metal
•
weld rolled 20g